Replacing a spiral tilt window balance is a common repair that is necessary when the window is no longer able to stay open or closed on its own. The balance is the mechanism that allows the window to remain in the position you set it at, and if it becomes worn out or broken, the window will no longer stay in place. Replacing the balance is a relatively simple process, but it does require some basic knowledge of how the window works and some basic tools.
The first step in replacing a spiral tilt window balance is to remove the window from the frame. This can be done by using a screwdriver to remove the screws that hold the window in place. Once the screws are removed, the window can be lifted out of the frame and set aside. It is important to be careful when removing the window, as it can be fragile and easily damaged.
Next, you will need to locate the balance. The balance is usually located on the side of the window frame and is usually held in place with two screws. Once the screws are removed, the balance should be able to be pulled out of the frame. Be careful not to damage the frame when removing the balance, as it can be easily damaged.
Once the old balance has been removed, you will need to measure the length of the balance. This is important, as the new balance must be the same length as the old one. Once the length has been determined, you can purchase a new balance at a local hardware store. Make sure to get the right size and type of balance for your window.
Once you have the new balance, you will need to install it into the window frame. Start by inserting the balance into the frame and then secure it with the screws. Once it is secure, you will need to adjust the tension on the balance. This can be done by turning the adjustment screws on the side of the balance. The adjustment screws should be turned in small increments until the balance is able to hold the window in the desired position.
Once the balance is adjusted, you can then reinstall the window into the frame. Make sure to secure the window with the screws, and then test the window to make sure the balance is working properly. If the window is still not able to stay in the desired position, you may need to adjust the balance again until it is able to hold the window in place.
Replacing a spiral tilt window balance is a relatively simple process that can be done with some basic tools and knowledge. It is important to be careful when removing and reinstalling the window, as it can be easily damaged. Once the balance is replaced, the window should be able to stay in the desired position without any further issues.